Investigation Results and Analysis of Solar Cells Performance Enhancement by Cooling using Thermoelectric Cooling (TEC)
PDF

Keywords

PV module, Solar cells, Peltier device, Laboratory tests, thermoelectric devices, PV cooling, spatial effect.

How to Cite

1.
Saddam Al-Otab, Mohammad Hamdan, Salman Ajib, Ahmad Manasrah. Investigation Results and Analysis of Solar Cells Performance Enhancement by Cooling using Thermoelectric Cooling (TEC). Glob. J. Energ. Technol. Res. Updat. [Internet]. 2019 Dec. 30 [cited 2024 Dec. 23];6(1):12-25. Available from: https://avantipublisher.com/index.php/gjetru/article/view/764

Abstract

 Solar energy received special attention and extensive studies were conducted to increase the efficiency of solar collectors and solar cells. One of the major problems of the operation of solar cells is the temperature rising which causes a reduction in the energy yield. The main objective of this work is to experimentally investigate the cooling effect of thermoelectric cooling devices (TEC) on solar cell performance. To overcome the rising temperature effect, the cooling by using the Peltier device is proposed and investigated. In this approach, the TEC cooling module is attached to the backside of the photovoltaic cell. It is assumed that the required power to run the TEC module is provided by the photovoltaic cell itself when the additional power obtained by the cooling is more than the needed power to operates the TEC device. The results show that the cooling of the tested PV cells/modules samples by using the Peltier TEC device was slightly enhanced the PV cells' performance. In our case of study for a 2Wp solar cell sample, the maximum temperature difference obtained due to Peltier cooling is about 5.3C° which produced an enhancement for the produced power and the open-circuit voltage by 7.02% and 2.64% respectively. However, the needed power to feed the Peltier element is significantly higher than the recovered power due to the Peltier cooling. The same trend was investigated for the tested samples of PV modules. So, the proposed combination of PV and Peltier cooling system was investigated to be economically not feasible regardless of the cost evaluation. Finally, the spatial effect and the proposed system can be improved significantly by altering and improving the performance of the Peltier element and the thermal characteristics of the solar cells/modules encapsulation material.
https://doi.org/10.15377/2409-5818.2019.06.2
PDF

References

The International Renewable Energy Agency (IRENA), Annual Renewable Capacity Statistics report 2019, Retrieved in 11/6/2019 from https://www.irena.org/publications/2019/ Mar/Renewable-Capacity-Statistics-2019

The International Renewable Energy Agency (IRENA), Annual Renewable Capacity Statistics report 2019, Retrieved in 11/6/2018 from By Good News Network - Apr 6, 2019. https://www.irena.org/publications/2019/Mar/Renewable- Capacity-Statistics-2019

International Electrotechnical Commission 60050 -191, Dependability and quality of service, 1990. renewable energy targets/European Commission 2020. https://ec.europa.eu/ energy/en/topics/renewable-energy

Renewable energy in Germany, 2018. Available: https://en.wikipedia.org/wiki/Renewable_energy_in_Germany

Quansah DA, Adaramola MS. Comparative study of performance degradation in poly- and mono-crystalline-Si solar PV modules deployed in different applications. Int J Hydrogen Energy 43(6): 3092-3109. https://doi.org/10.1016/j.ijhydene.2017.12.156

Chandel SS, Tanya A. Review of cooling techniques using phase change materials for enhancing efficiency of photovoltaic power systems. Renewable and Sustainable Energy Reviews 2017; 73: 1342-1351

Sieckera J, Kusakanaa K, Numbib BP. A review of solar photovoltaic systems cooling technologies, Renewable and Sustainable Energy Reviews 2017; 79: 192-203.

Holman JP. Textbook, Experimental Methods for Engineers, 8th Edition.

Al-Otab S, Salman A, Wolf L. A Comparative Investigation on Outdoor and Laboratory Test of the Degradation Rates for Different Types of Photovoltaic Modules with Different Exposure Periods, Global Journal of Energy Technology Research Updates 2018; 5: 56-71.

All the published articles are licensed under the terms of the Creative Commons Attribution Non-Commercial License (CC BY-NC 4.0) which permits unrestricted, non-commercial use, distribution and reproduction in any medium, provided the work is properly cited.