Comparison of the Critical Mass Flow Rates for Two Serpentine Designs of the Photovoltaic Solar Thermal Collector
PDF

Keywords

Solar energy
Photovoltaic solar thermal collector
Surpentine collector design
Critical mass flow rate
Pumping requirement
Photovoltaic cell efficiency

How to Cite

1.
Sakhr M. Sultan, C.P. Tso, M.N. Ervina Efzan. Comparison of the Critical Mass Flow Rates for Two Serpentine Designs of the Photovoltaic Solar Thermal Collector. J. Adv. Therm. Sci. Res. [Internet]. 2020 Dec. 31 [cited 2025 Feb. 3];7(1):56-69. Available from: https://avantipublisher.com/index.php/jatsr/article/view/971

Abstract

A recent analysis on the photovoltaic (PV) cell efficiency for the photovoltaic solar thermal collector (PVT), cooled by forced fluid flow, revealed that there is, in general, a critical mass flow rate that corresponds to the maximum PV cell efficiency for a PVT. The derived new equations are applicable for laminar and transition or turbulent flow regimes and could yield directly the critical mass flow rate as compared with existing methods that use repeated computational trials. To demonstrate further the generality of the method, this paper reports results on comparing the critical mass flow rates for two serpentine designs with different technical details, namely Design A and Design B, using the new equations. It is shown that Design A and Design B have critical mass flow rates of 0.041 and 0.014 kg/s, respectively. The corresponding Reynolds numbers are 4078 and 2785 for Design A and Design B, respectively. It is shown that the critical mass flow rate is different from one design to another. The importance of the critical mass flow rate is summarized.

https://doi.org/10.15377/2409-5826.2020.07.7
PDF

References

Sultan SM, Tso CP, Ervina EMN. A New Method for Reducing the Performance Evaluation Cost of the Photovoltaic Module Cooling Techniques using the Photovoltaic Efficiency Difference Factor. Case Studies in Thermal Engineering 2020; 100682. https://doi.org/10.1016/j.csite.2020.100682

Sultan SM, Tso CP, Ervina EMN. A New Production Cost Effectiveness Factor for Assessing Photovoltaic Module Cooling Techniques. International Journal of Energy Research 2020; 44: 574-583. https://doi.org/10.1002/er.4889

Sultan SM, Tso CP, Ervina EMN. A New Approach for Photovoltaic Module Cooling Technique Evaluation and Comparison using the Temperature Dependent Photovoltaic Power Ratio. Sustainable Energy Technologies and Assessments 2020; 93: 100705. https://doi.org/10.1016/j.seta.2020.100705

Sultan SM, Tso CP, Ervina EMN. Comments on Performance Evaluation of Photovoltaic Thermal Solar Air Collector for Composite Climate of India. Solar Energy Materials and Solar Cells 2019; 198: 63-64. https://doi.org/10.1016/j.solmat.2019.03.043

Sultan SM, Tso CP, Ervina EMN. A Proposed TemperatureDependent Photovoltaic Efficiency Difference Factor for Evaluating Photovoltaic Module Cooling Techniques in Natural or Forced Fluid Circulation Mode. Arabian Journal for Science and Engineering 2019; 44: 8123. https://doi.org/10.1007/s13369-019-03932-5

Sultan SM, Tso CP, Ervina EMN. Review on Recent Photovoltaic/Thermal (PV/T) Technology Advances and Applications. Solar Energy 2018; 173: 939-54. https://doi.org/10.1016/j.solener.2018.08.032

Sultan SM, Tso CP, Ervina EMN. A Case Study on Effect of Inclination Angle on Performance of Photovoltaic Solar Thermal Collector in Forced Fluid Mode. Renewable Energy Research and Applications 2019; 173: 187-196.

Garg HP, Agarwal RK. Some Aspects of a PV/T Collector/ Forced Circulation Flat Plate Solar Water Heater with Solar Cells. Energy Conversion and Management 1995; 36(2): 87- 99. https://doi.org/10.1016/0196-8904(94)00046-3

David G, Iván A, Montserrat D, Cristina A. Experimental analysis of a novel PV/T panel with PCM and heat pipes. Sustainability, 2020; 12: 1710. https://doi.org/10.3390/su12051710

Mohammad HA, Alireza B, Milad S, Mohammad Z, Amir M, Shahaboddin S, Ravinder K, Mohammad M.. Evaluation of electrical efficiency of photovoltaic thermal solar collector. Engineering Applications of Computational Fluid Mechanics, https://doi.org/10.1080/19942060.2020.1734094

Tao M, Meng L, Arash K.. Photovoltaic thermal module and solar thermal collector connected in series to produce electricity and high-grade heat simultaneously. Applied Energy. 2020; 261: 114380. https://doi.org/10.1016/j.apenergy.2019.114380

Shyam, Tiwari GN, Olivier F, Mishra RK, Al-Helal, IM. Performance evaluation of N-photovoltaic thermal (PVT) water collectors partially covered by photovoltaic module connected in series: An experimental study. Solar Energy. 2016; 134: 302-313. https://doi.org/10.1016/j.solener.2016.05.013

Erkata Y. Methods for the Development and Testing of Polymeric Hybrid Photovoltaic Thermal (PVT) Collector for Indoor Experiments. MethosX. https://doi.org/10.1016/j.mex.2019.10.021

Niccolò, A, Claudio DP, Fabrizio L, Massimiliano M. Performance monitoring and modeling of an uncovered photovoltaic-thermal (PVT) water collector. Solar Energy. 2016; 135: 551-568. https://doi.org/10.1016/j.solener.2016.06.029

Touafek K, Kerrour F. Model Validation of an Empirical Photovoltaic Thermal (PVT) Collector. Energy Procedia. 2014; 74: 1090-1099. https://doi.org/10.1016/j.egypro.2015.07.749

Koronaki IP, Nitsas MT. Experimental and theoretical performance investigation of asymmetric photovoltaic/thermal hybrid solar collectors connected in series. Renewable Energy. 2018; 118: 654-672. https://doi.org/10.1016/j.renene.2017.11.049

Vidya SG, Desh BS, Mishra RK, Sanjeev KS, Tiwari GN. Development of characteristic equations for PVT-CPC active solar distillation system. Desalination. 2018; 445: 266-279. https://doi.org/10.1016/j.desal.2018.08.009

Rohit T, Tiwari GN. Annual performance evaluation (energy and exergy) of fully covered concentrated photovoltaic thermal (PVT) water collector: An experimental validation. Solar Energy. 2017; 146: 180-190. https://doi.org/10.1016/j.solener.2017.02.041

Tiwari GN, Md M, Khan ME. Exergy analysis of Nphotovoltaic thermal-compound parabolic concentrator (NPVT-CPC) collector for constant collection temperature for vapor absorption refrigeration (VAR) system. Solar Energy. 2018; 173: 1032-1042. https://doi.org/10.1016/j.solener.2018.08.031

Evangelos S, Petros A. An experimentally validated, transient model for sheet and tube PVT collector. Solar Energy. 2018; 174: 709-718. https://doi.org/10.1016/j.solener.2018.09.058

Jianhui H, Wujun C, Deqing Y, Bing Z, Hao S, Binbin, G. Energy performance of ETFE cushion roof integrated photovoltaic/thermal system on hot and cold days. Applied Energy. 2016; 173: 40-51. https://doi.org/10.1016/j.apenergy.2016.03.111

Maysam G, Mehran A. Energy and exergy analyses of Photovoltaic/Thermal flat transpired collectors: Experimental and theoretical study. Applied Energy. 2016; 164: 837-856. https://doi.org/10.1016/j.apenergy.2015.12.042

Monia C, Wael C, Hatem M, Philippe, B. Performance evaluation of concentrating solar photovoltaic and photovoltaic/thermal systems. Solar Energy. 2013; 98: 315- 321. https://doi.org/10.1016/j.solener.2013.09.029

Proell M, Karrer H, Brabec CJ, Hauer A. The influence of CPC reflectors on the electrical incidence angle modifier of cSi cells in a PVT hybrid collector. Solar Energy. 2016; 126: 220-230. https://doi.org/10.1016/j.solener.2016.01.012

Bernardo LR, Perers B, Hakansson H, Karlsson B. Performance evaluation of low concentrating photovoltaic/thermal systems: A case study from Sweden. Solar Energy. 2011; 85: 1499-1510. https://doi.org/10.1016/j.solener.2011.04.006

Kunnemeyer R, Anderson TN, Duke M, Carson JK. Performance of a V-trough photovoltaic/thermal concentrator. Solar Energy. 2014; 101: 19-27. https://doi.org/10.1016/j.solener.2013.11.024

Chaoqing F, Hongfei Z, Rui W, Xinglong M. Performance investigation of a concentrating photovoltaic/thermal system with transmissive Fresnel solar concentrator. Energy Conversion and Management. 2016; 111: 401-408. https://doi.org/10.1016/j.enconman.2015.12.086

Chemisana D, Rosell JI, Riverola A, Lamnatou C. Experimental performance of a Fresnel-transmission PVT concentrator for building-façade integration. Renewable Energy. 2016; 85: 564-572. https://doi.org/10.1016/j.renene.2015.07.009

Milad M, Reza H. A photovoltaic/thermal system with a combination of a booster diffuse reflector and vacuum tube for generation of electricity and hot water Production. Renewable Energy. 2015; 78: 245-252. https://doi.org/10.1016/j.renene.2015.01.010

Othman MY, Hamid SA, Tabook MAS, Sopian K, Roslan M, Ibarahim HZ. Performance analysis of PVT Combi with water and air heating system: An experimental study. Renewable Energy. 2016; 86: 716-722. https://doi.org/10.1016/j.renene.2015.08.061

Wei P, Yanan C, Qian Z, Hongwen Y, Xiaoyan Z, Yongzhe Z, Hui Y. Comparative investigation of performances for HIT-PV and PVT systems. Solar Energy. 2019; 179: 37-47. https://doi.org/10.1016/j.solener.2018.12.056

Franz H, Christian H, Franz I, Peter K. System efficiency of pvt collector-driven heat pumps. International Journal of Thermofluids 2020; 5-6: 100034. https://doi.org/10.1016/j.ijft.2020.100034

Renato L, Marco N. Photovoltaic/thermal (PV/T)/ground dual source heat pump: Optimum energy and economic sizing based on performance analysis. Energy & Buildings. 2020; 211: 109800. https://doi.org/10.1016/j.enbuild.2020.109800

Vaishak S, Purnanand VB. Performance analysis of a heat pump-based photovoltaic/thermal (PV/T) system. Clean Technologies and Environmental Policy. 2020. https://doi.org/10.1007/s10098-020-01839-6

Fayaz H, Rahim NA, Hasanuzzaman M, Rivai A, Nasrin R. Numerical and outdoor real time experimental investigation of performance of PCM based PVT system. Solar Energy. 2019; 179: 135-150. https://doi.org/10.1016/j.solener.2018.12.057

Sajan P, Brij B, Tarun M. Experimental investigation of water based photovoltaic/thermal (PVT) system with and without phase change material (PCM). Solar Energy. 2017; 155: 1104-1120. https://doi.org/10.1016/j.solener.2017.07.040

Ibrahim A, Jin GL, Daghigh R, Salleh MHM, Othman MY, Ruslan MH, Mat S and Sopian K, Hybrid Photovoltaic Thermal (PV/T) Air and Water Based Solar Collectors Suitable for Building Integrated Applications. American Journal of Environmental Sciences 2009; 5(5): 618-624. https://doi.org/10.3844/ajessp.2009.618.624

Yazdanifard F, Ebrahimnia-Bajestan E, Ameri M. Investigating the performance of a water-based photovoltaic/thermal (PV/T) collector in laminar and turbulent flow regime. Renew. Energy. 2016; 99: 295-306. https://doi.org/10.1016/j.renene.2016.07.004

Ameri M, Mahmodabadi MM, Shahsavar A. An experimental study on a photovoltaic/thermal (PV/T) air collector with direct coupling of fans and panels Energy Sources. 2012; 34: 929-947. https://doi.org/10.1080/15567031003735238

Sultan SM, Tso CP, Ervina EMN. Alternative determination of critical mass flow rate for the photovoltaic solar thermal collector in forced fluid mode. Case Studies in Thermal Engineering. 2021; 23: 100805. https://doi.org/10.1016/j.csite.2020.100805

Cengel, Y. A., and Cimbala, J. Fluid and Mechanics fundamentals and applications. Mc Graw Hill. 2006.

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.